CP Pistons Kawasaki Prairie 700 KFX700 Piston Kits Standard Bore, Big Bore and High Compression Pistons

CP Pistons 2003 - 2007 Kawasaki KFX700 and 2004 - 2006 Prairie 700 Piston Kits

V-Twin Engine Stock Standard Bore size is 82mm (3.228") Stock Stroke is 66mm (2.598")

Please Note: This is a V-Twin engine. The part numbers listed below are for 1 piston kit including 1 piston, 1 piston pin, 1 cylinders worth of piston rings, and pin locks for 1 piston. You will need to order 2 each of any of the below part numbers in order to replace both pistons in your engine.

Cometic top end gasket sets are available separately, but are not included with the piston kit. The matching top end gasket kit for each application is listed in the table, along with the individual piston kit info.

Installation Notes:

• Deglaze Cylinder When replacing a piston with the same stock bore size as the original factory stock size you do not need to have your cylinder modified. We do recommend that you deglaze the cylinder. This involves running a hone through the cylinder to remove glazing and provide the best possible surface for piston ring seal. This will improve power and piston and ring life.
• Bore and hone Cylinder When installing an oversize, big bore piston, the cylinder must be bored to the correct new bore size to allow installation of your oversize piston. The cylinder then must be finish honed to provide the proper surface for your piston and rings to work with, and provide best power and longevity.